ES Windows Kitchen Remodeling Nationwide

ES Windows Kitchen Remodeling: The Los Angeles Owner’s Guide

ES Windows kitchen remodeling in Los Angeles typically runs $16,520 to $53,100 installed, with most mid-range projects landing in the mid-thirties. We stock ES Windows-compatible frames, sashes, and hardware across the 5000, 7000, and 9000 series, and we can usually match your existing window configuration without a full-frame replacement. Most Los Angeles homeowners discover their ES Windows units are failing when the coastal salt air has corroded the weep screed (the drainage channel at the sill) or when the dual-pane seal has blown after a decade of thermal cycling between inland valley heat and marine layer cool.

Call (213) 652-7670

Which ES Windows Models This Applies To

ES Windows organizes its residential line into series numbers that correspond to frame depth and impact rating. The 5000 series is a 2-inch non-impact vinyl frame common in pre-2015 Los Angeles builds, the 7000 series steps up to 2.5 inches with laminated glass for HVHZ (High Velocity Hurricane Zone) compliance, and the 9000 series is the 3-inch commercial-grade aluminum frame you’ll see in Westside condos and newer ADUs. The critical compatibility gotcha is the sash cam: 5000 and 7000 series use a rounded cam that locks into a tilt-wash shoe, while the 9000 series uses a squared cam that won’t seat in older hardware. Check the etched mark in the glass corner, it lists the series, the NFRC rating, and the manufacturing plant code (Miami is MIA, the secondary plant is TPA).

We source OEM balances, sash locks, and tilt latches directly from ES Windows’s Florida distribution center, with a ten-day lead time on custom sizes. For standard 24-by-36, 30-by-54, and 36-by-72 inch units, we stock quality aftermarket equivalents from Amesbury Truth that match the ES Windows spec on cam profile, spring weight, and pile height (the fuzzy weatherstrip that seals against the frame). The aftermarket route saves roughly 15 percent on parts without affecting the warranty on our installation work.

Signs Your ES Windows Kitchen Remodeling Is Failing

• Condensation between the panes. This means the dual-pane seal has failed, the desiccant inside the spacer bar is saturated, and the Low-E coating is degrading from moisture exposure. In Los Angeles, we see this accelerate within three miles of the coast where salt aerosol penetrates the primary seal.
• Window won’t stay open or slams shut. The coil balance, a constant-force spring that counterweights the sash, has lost tension or the plastic pivot bar has sheared. ES Windows 5000-series balances are rated for 10,000 cycles, heavy kitchen use in a rental can hit that in six years.
• Visible water staining on the drywall below the sill. The weep screed is clogged with stucco dust or the sill pan (the sloped flashing that directs water outward) was never properly integrated with the housewrap. In Los Angeles’s clay-heavy soils, foundation settling can torque the frame and break the sill pan seal.
• Draft even when the window is locked. The pile weatherstrip has compressed past recovery or the interlock (the meeting rail where the two sashes overlap) has bowed from thermal expansion. South-facing kitchen windows in the San Fernando Valley see 140-degree surface temperatures in August, the PVC frame expands 0.004 inches per degree Fahrenheit.
• Crank handle spins without moving the sash (casement units). The worm gear in the roto operator has stripped, usually because the hinge arm was binding and the operator was forced past its mechanical stop. ES Windows casement operators use a 11/32-inch spindle, aftermarket operators with a 3/8-inch spindle will chew the gear in weeks.

Before

After

Replacement Cost & What’s Included

The spread on full-frame replacement comes down to three factors: whether the exterior is stucco (requires specialty saw cut and patch) or siding; whether the existing opening is plumb and square (older Los Angeles bungalows often run 1/2 inch out over 36 inches); and whether the city requires a Title 24 energy compliance form for the replacement, which adds a plan check fee and a HERS rater verification. Under Clause 1 of the Haven Standard, we deliver a written price that includes all three variables before any work starts, every time. The 365-Day Done Right Promise covers the installation, the ES Windows OEM parts carry a 20-year glass and 10-year hardware warranty from the manufacturer.

DIY or Call Us?

There’s a safe middle ground here. A homeowner can verify the series number from the glass etch, measure the daylight opening (the visible glass width and height, not the frame), and check whether the weep screed holes are visibly clogged with a flashlight. What we don’t recommend is removing a fixed sash or attempting to rewind a coil balance, the spring is under 12 to 15 pounds of tension and the plastic retaining clip can fracture without warning, sending metal components into the room. We’ve been called to three Los Angeles homes in the past two years where a DIY balance replacement resulted in a laceration or a dropped sash that cracked the new dual-pane unit. If the window is above a counter or sink, the fall hazard is real.

Our crews carry ES Windows-compatible balances, operators, and sash cams on every kitchen remodeling truck in Los Angeles. Call (213) 652-7670 and we’ll schedule a free estimate, measure on-site, and if it’s a stock item we can usually return with parts within the project timeline. If it’s not written down, it didn’t happen, so you’ll get the scope, the price, and the warranty in writing before anyone picks up a tool.

FAQs