Quikrete Driveway & Pavers Nationwide

Quikrete Driveway & Pavers: The Los Angeles Owner’s Guide

We stock and install Quikrete-compatible driveway and paver systems across Los Angeles, with most replacement and repair projects running $5,310-$21,240 depending on scope, material grade, and substrate condition. Quikrete’s concrete mixes and paver base products are widely used in Los Angeles County residential work, and we carry the full range of compatible reinforcement, expansion joint, and surface treatment components on our trucks. Most homeowners discover their Quikrete driveway or paver installation is failing when surface cracking spreads beyond hairline width, when pavers begin rocking underfoot, or when water pools in sections that previously drained clean after rain.

Call (213) 652-7670

Which Quikrete Models This Applies To

Quikrete does not manufacture driveways or pavers as finished products; they produce the cementitious mixes, base materials, and repair compounds that contractors and DIYers use to build them. In Los Angeles, we most commonly encounter three Quikrete product families in existing residential driveway and paver work: the Crack Resistant Concrete Mix (No. 1006-80) used for slab pours, the Patio Paver Base (No. 1150-49) installed as the 4-inch bedding layer, and the Re-Cap Concrete Resurfacer (No. 1131-11) applied as a thin restoration coat.

To identify what’s in your driveway, check for product bags left behind in garage corners or side yards, or look for stamped lot numbers on any visible expansion joint material. The critical compatibility gotcha in Los Angeles is the Re-Cap Resurfacer: it bonds poorly to surfaces previously sealed with acrylic or epoxy coatings, a common post-installation treatment in Mid-City and West Adams properties from the 2010s. We always test a 1-foot patch before quoting a full resurfacer job. For paver base work, the No. 1150-49 is functionally equivalent to Class II road base per Caltrans spec, but we verify gradation on site because some suppliers in the San Fernando Valley have shipped blended fines that compact too soft for vehicular load.

Rowan Construction Group Los Angeles is an independent service provider, not affiliated with Quikrete. We source OEM Quikrete products and quality aftermarket equivalents from Sakrete and Spec Mix where the spec matches and the price advantage is real.

Signs Your Quikrete Driveway & Pavers Is Failing

• Spiderweb cracking across the slab surface. This is map cracking or crazing, caused by rapid moisture loss during cure, overworking the surface, or using a mix too wet for Los Angeles summer conditions. In our experience, it appears most often on Quikrete pours done in August without proper fog curing.
• Paver units rock or settle when stepped on. The bedding layer has eroded or was inadequately compacted during install. In Los Angeles, this follows poor drainage design on sloped lots in Silver Lake and Echo Park, where winter storm runoff undercuts the base.
• Cracks wider than a quarter inch with vertical displacement. This is structural failure of the slab or base, usually from tree root intrusion, expansive clay soil movement, or insufficient control joint depth. We see this regularly in the Hollywood Hills where fill soils were poorly compacted during original grading.
• Surface spalling or flaking, especially after rain. The top paste layer is delaminating, typically from freeze-thaw cycling on sealed surfaces, or from salt exposure near pool equipment. Quikrete Re-Cap can address this if the substrate is sound; if not, partial replacement is the honest recommendation.
• Efflorescence: white powder blooming on the surface. Soluble salts migrating through the porous matrix. It’s cosmetic but indicates moisture is moving through the slab continuously, which degrades any applied coating and signals a drainage or vapor barrier failure below.

Before

After

Replacement Cost & What’s Included

The range depends on three factors we itemize in every written quote: square footage, excavation and haul-off requirements, and whether the existing substrate can be salvaged or must be removed to native soil. A Quikrete driveway pour on stable, well-draining ground in Palms runs toward the lower end; the same spec in the Hollywood Hills with engineered fill and geogrid stabilization runs higher. Under Clause 1 of the Haven Standard, that written price is delivered before any work starts, and no change proceeds without a signed change order. Our 365-Day Done Right Promise covers the installation; manufacturer warranties on Quikrete products are handled per their published terms.

DIY or Call Us?

There is honest DIY work and honest work that isn’t DIY. For Quikrete driveway and paver issues, a homeowner can safely check: whether drainage gutters are clear of debris, whether crack width has changed seasonally, and whether the surface slopes away from the foundation as designed. Photograph these conditions; they’re useful for any contractor you call.

Where DIY goes wrong is in the substrate. Removing and replacing a failed Quikrete slab without verifying compaction, without a plate compactor rated for the soil type, and without understanding how Los Angeles clay soils expand and contract with moisture changes, produces a repeat failure in two to three years. We’ve torn out three-year-old DIY pours in Mar Vista where the homeowner skipped the subgrade prep to save a day. The re-do cost more than our original quote would have.

Call (213) 652-7670 to schedule your free estimate. We’ll document current conditions with a photo record you keep, and deliver a written price with line-item scope before any work starts.

FAQs